2003-2004 HONDA GL 1800/A Frame Weld Safety Recall
download there is no punch mark on the VIN plate as specified in this Service Bulletin, proceed to the REPAIR PROCEDURE section of this Service Bulletin. IMPORTANT: Due to the complexity of this...
View ArticleHarley-Davidson FL Models (1993-2009) HARLEY PASSENGER FLOORBOARD COMFORT KIT...
download 1. Using your 5/16″ allen wrench, unscrew the Cap head allen bolts attaching the stock passenger floorboard mount to the frame and remove the assembly. You will reinstall this assembly once...
View Article2002-2003 Honda GL1800/ A Frame Weld REPAIR PROCEDURE OVERVIEW
download If your inspection identifies a crack or cracks in or on either Left or Right lower crossmember frame welds, STOP – call your DSM or TechLine for further instructions. • If your inspection...
View ArticleBMW Motorcycle R 1100 RS – Rear Frame
download Complaint: On R 1100 RS models (above serial numbers only) with luggage racks, a crack may develop in the rear section of the frame (see drawing) if a load exceeding the permitted 11 lb. is...
View ArticleSUZUKI 2005-2006 GSX-R1000 MOTORCYCLES FRAME REINFORCEMENT BRACE...
download Bodywork removal 1. Refer to section 8 of the service manual and remove the following: a) Right and left Under Cowlings (NOTE: Two of these screws will NOT be re-installed) b) Cover, Front...
View ArticleKawasaki Teryx Dash Frame Installation Manual
download The BRP Dash Frame mounts in place of the factory cup holder/storage pocket. Remove the screws holding the cup holder or storage pocket from the back of the dash and remove it. Hold the Dash...
View ArticleHARLEY DAVIDSON LOCKING GLOVE BOX DOOR KIT INSTALLATION MANUAL
download INSTALLATION 1. Unsnap the original equipment (O.E.) left-side glove box door, and unfasten the tether by bringing the aglet end (see Figure 1, B) out through the retaining hole. Always wear...
View ArticleHARLEY DAVIDSON XL SPRING SEAT MOUNTING KIT INSTALLATION MANUAL
download INSTALLATION 1. Refer to service manual and remove the existing seat, seat post, washer and screw. Do not remove grommet or T-spacer from rear fender. Save the washer and screw for later...
View ArticleHARLEY DAVIDSON MID-FRAME AIR DEFLECTORS INSTALLATION INSTRUCTIONS
download INSTALLATION Model Years 2001-2007 1. Refer to Owner’s Manual and remove seat. 2. Remove stock plastic cruise control cable clip from frame near end of fuel tank if equipped. 2 1 is04321a 1....
View ArticleHARLEY DAVIDSON SECURITY SYSTEM KITS INSTALLATION INSTRUCTIONS
download FL Touring models equipped with a TLE/ TLE Ultra Sidecar will require the additional installation of a Bank Angle Switch Kit (88115-03) and is available for separate purchase. See a...
View Article
More Pages to Explore .....